How Do You Reset The Oil Change Light On A Jeep Grand Cherokee?

  • fully depress the accelerator pedal slowly three times within 5 seconds and the OIL LIFE is reset.
  • Turn off the ignition, then start the engine normally and the light should be reset.
  • via

    How do you reset the oil change light on a 2006 Jeep Grand Cherokee?

    Locate the "Step" button on the Grand Cherokee's instrument panel and press it. Press it again until it says "Miles to Service." Press in and hold the button for about five seconds. It should read "Reset." This will turn off the service light on the display. via

    How do you reset the oil change light on a 2008 Jeep Grand Cherokee? (video)

    How do I reset my Jeep Grand Cherokee?

    In order to do this You will need to press and hold both the temperature up and temperature down buttons on the driver side of the controls. Do not let go until the display changes to the engineering menu. Scroll down in the menu until You see Reset to factory default and press it. via

    How do you reset the change oil light on a Jeep?

    Without starting the engine, turn the ignition in the ON/RUN mode position. In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.” Push and hold the 'OK' button until the oil life gauge resets to 100%. via

    How do you reset the change oil light on a 2005 Jeep Grand Cherokee? (video)

    How do you reset the change oil light on a 2009 Jeep Grand Cherokee?

  • Turn the ignition switch to the ON position, do not start the engine.
  • Fully depress the accelerator pedal slowly three times within 10 seconds.
  • Turn the ignition switch to the OFF/LOCK position.
  • via

    How do you reset the change oil light on a 2002 Jeep Grand Cherokee? (video)

    How do you reset the service light on a Jeep Cherokee?

  • Turn the ignition switch to the "ON" position without starting the vehicle.
  • Press the gas pedal to the floor slowly three times within 10 seconds.
  • Turn the ignition off. Wait 10 seconds and start the engine.
  • via

    How do you reset the oil light on a 2008 Jeep Compass? (video)

    How do you turn off the change oil light on a Jeep Cherokee?

    On the steering wheel, navigate to the “Oil Life” selection under “Vehicle Info“. Push and hold the OK button until the oil light percentage changes to 100%. Press the Start/Stop button to turn the electronics off. via

    Where is the TPMS reset button on a 2007 Jeep Grand Cherokee?

    With a gauge, check each tire is inflated to a PSI of 33. If normal driving doesn't recalibrate the pressure monitoring system, place the key in the ignition and switch to the "on" position without firing the engine. Depress the TPMS button located under the steering wheel until it flashes three times. via

    How do I reset my UConnect 2020?

  • Ensure your vehicle is in park and in “Run” mode.
  • Press and hold down the volume and tuner knob buttons at the same time.
  • Hold down the knobs for 10 – 20 seconds.
  • After holding down the knobs, the screen should flash your vehicle brand name and then go dark.
  • via

    How do you clear the error code on a Jeep Grand Cherokee?

  • Pull the release lever to open the hood from inside the vehicle.
  • Open the hood and place the support rod into position to prop up the hood.
  • Remove the nut connecting the negative battery terminal to the battery, using an open end wrench.
  • Allow the computer to reset.
  • via

    Leave a Comment

    Your email address will not be published. Required fields are marked *